Moises Nieves

yeah i had static problems before ill look into it right now

the last time i tried to cut it out it was working fine then just stopped towards the end of the cut and didnt finish the design

i will give it a try thank you

i have a sheet of vinyl about 38-39 in long and as it feeds through for the area test it just feeds the sheet right out and the rollers keep going for a little bit longer after it rolls the whole sheet through

i am trying cut out a banner for the front windshield of a car at about 34 inches long 4 inches wide but the vinyl cutter when i perform a area test goes over the 34 inches but i just set it to about 30 and it seemed to get that measurement right and work fine not going over or anything.. i am thinking its possibly my computer that i am using but i have no clue

i am using vinyl master

i am using vinyl master

Im having a problem where my cutter is going bigger then the actual measurements and i cant seem to find the problem if i do an area test it just keeps on rolling past the measurement...