teddyu

Members
  • Content Count

    13
  • Joined

  • Last visited

  • Days Won

    1

teddyu last won the day on December 1 2019

teddyu had the most liked content!

Community Reputation

2 Neutral

About teddyu

  • Rank
    Member
  1. teddyu

    Replaced Z chip

    Was a disconnected cable. put a new display in and knocked one of the cables off didn't know it so I replaced z chip did not help so I took back apart and found the cable unplugged... plugged it back up and runs fine now! I now have 20 good z chips if anyone needs one.
  2. teddyu

    I have Z chips

    Anyone how needs a Z Chip let me know.
  3. teddyu

    Replaced Z chip

    Don’t see any questions when I go to the link.
  4. teddyu

    Replaced Z chip

    I replaced my Zchip and still no blade up and down!
  5. teddyu

    Z chip For MH 721

    Dakotagrafx found the same Texas Instrument LM324N chip online hope its the same chip looks the same anyway will see!
  6. teddyu

    Z chip For MH 721

    Thanks MZ SKEETER I have already done that believe me! And one thing I don't understand is they say not to put magnets near the cutter but that's part of the static kit? anyway thanks again for all the help!
  7. teddyu

    Z chip For MH 721

    Just ordered 10 online with the same part# hope that it works!
  8. teddyu

    Z chip For MH 721

    Dakotagrafx my Z chip is Texas Instruments part# 05D1E4K LM324N
  9. teddyu

    Z chip For MH 721

    Will get back to ya tomorrow with part number worked late tonight. Thanks
  10. teddyu

    Z chip For MH 721

    Don’t know at work will let you know later. Thanks
  11. Does anyone know where I can purchase a Z chip for my MH 721? I have looked for cutters on Craigslist and eBay for parts but can’t find any and all the places online are sold out!
  12. teddyu

    Blade will not go up or down.

    No I did not ground it and yes you can move the holder up and down.
  13. I just got a stand for my MH 721 put it together and sat the cutter on it and the blade will not go up or down now. Can anyone help?