Hi there! I have very uncommon problem with my setup - not sure if it's plotter or software oriented.
THE SETUP:
Plotter is Graphtec FC7000-100 with latest firmware 2.10 GL - updated just recently, but problem occurred with previous version too. Set as GP-GL. Connected via USB.
Windows 7, Cutting Master 2 and - if it even matters - Corel Draw X7.
THE PROBLEM:
After loading and measuring vinyl sheet plotter shows it's correct dimensions (mm).
But Cutting Master program, reads these dimensions 10x bigger!
Any clues? Please look at images:
Cut Area on plotter is 532x248 MM
But Cutting Master shows 532x248 CM
Any clues? Please help!