sheryar
-
Content Count
6 -
Joined
-
Last visited
Posts posted by sheryar
-
-
47 minutes ago, MZ SKEETER said:Did you purchase your cutter from UScutter? Also with you not knowing how to run this machine, you have the S30 way too fast. I run at very slow and you should until you learn the cutter. Like speed 2. And the F14. Is your force. You need to set your blade depth first, This is how to correctly do it
To start with, you should set your blade depth correctly, by taking the blade holder out of the machine, and firmly cut across a piece of scrap vinyl, you will be cutting. You should only be cutting the vinyl and barely a mark on wax paper backing, Adjust blade to get there, Then put the blade holder back in machine, and use the force of the machine to get there, same results, only cutting the vinyl and barely a mark in wax paper backing. You should just barely see and feel the blade tip out of the blade holder.
Omg, this helped so much, solved a lot of issues, thank you so much!
For the Graphtec Studio pro it looked very confusing that's why I was trying to use Graphtec Studio only, I just ran Graphtec Studio Pro and cutter works on that but it doesn't show up on the other software idk why. In the pro version, how do I change the roll media width when cutting, it's not letting me? Also is there any videos where i can learn how to use this software, because I can't seem to find tutorials on youtube- 1
-
-
-
1 hour ago, MZ SKEETER said:Did you reboot your computer after installing the drivers? Do you have the cutter Command on GP-GL? Graphtec Studio is Graphtec language. Make sure your cutter is turned on and ready to cut. Make sure you already have your conditions set first, blade depth, speed and force, and blade offset. which is ZERO on a Graphtec.
Hello thanks for the reply, i have rebooted, language is in GP-GL, cutter says ready, am not sure about the conditions, how to do that, i dont get why the cutter doesnt show up on Graphtec studio cutter options, please see attached 2 pictures for better idea
-
Hello i just bought a Graphtec CE6000-60 plus, i have installed all the drivers and everything on my windows 7 laptop, the printer shows up on my printer options on control panel but it does not show up on Graphtec studio cutters so I can't send any print job, i don't know what to do, anything helps, so frustrated
Please let me know
New Graphtec cutter not showing up on Graphtec Studio
in GraphTec Cutting Plotter Support Requests
Posted
I have a 15 inch roll on my cutter but the settings are for 24 inch roll, i want to change it so i can fit all designs to cut on 15 inch roll setting