802 Custom Vinyl

Members
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About 802 Custom Vinyl

  • Rank
    Newbie
  1. 802 Custom Vinyl

    Not aligning cuts properly MH-871

    I am using VinylMaster LTR v4.0. I think it has a similar option which might be the "Strip Mode" might try that and see what happens
  2. 802 Custom Vinyl

    Not aligning cuts properly MH-871

    So I only really do this as a hobby and not really a big thing yet. I cant afford to go Roland or any of those really right yet. If I were to get a different cutter is the Laserpoint any better? It's still considered a value cutter so I don't want to potentially waste more money for something that's not going to work.
  3. So I am trying to cut a Large decal (90" X17") for the side of a truck and the very ends aren't matching up. I have tried making sure my pinch rollers are adjusted, done a calibration to make sure offset was in the proper position and adjusted speed and force. Still cutting the same way. I have made sure to triple check the straightness of the vinyl when I've placed it in the rollers. I have less than 1CM of travel side to side over the course of 3 feet in material. But every time it does the same thing. I have now tried to cut this 3 times and am wasting a lot of material. Its almost like the middle portion isn't being centered properly in the outer. I've attached some images of whats going on and also the design I'm using so you can see what I mean. And don't worry I work for a Chevrolet Dealer and this is for one of our trucks. No copyright issues here lol. Any suggestions? Thanks in advance