IamDave
-
Content Count
7 -
Joined
-
Last visited
Posts posted by IamDave
-
-
-
Thanks for the information. I'm determined to figure out how to do this and I will post the fix when finished.
Dave
-
I see the checkbox adds or removes the cut line but it does not advance to the cut trough when finished.
Thanks,
Dave
-
Using two of the Titan-2 28” at my work and I have a Titan-3 SE 28” at home, all are using Vinylmaster DSR V4.0.
Using the Titan-2 this past week I had a 30 piece 3-layer vinyl project and each layer of the design was about 20x20 inches.
One thing that would have made this project a little easier if I could figure out how the “Advance After Plot” works. This is at the bottom of the attached photo. What I think this is supposed to do is advance to the cut trough so you can make the cut. Doesn’t appear to work checked or unchecked. I have been manually advancing the X position on the Titan-2 to 120 to make the cut and then back to 15 for the next plot. The Titan-3 has a different cut trough location. Have not found any setting in Vinylmaster or in the cutter itself for the “Advance After Plot” length.
I hope this is not a repeat question as I have searched through the forum and did not find a solution.
Any ideas would be appreciated.
Thanks,
Dave
-
-
Well, this is a year and a half too late but that was likely made on a CarveWright. If you look closely there are vertical lines in the recess of the carve, mine do the same.
- 2
Vinylmaster DSR V4.0 Force control is missing
in VinylMaster CUT, LTR, PRO & DSR
Posted
Reinstalled Vinylmaster.