kawaii

oh no! that's so sad (for me)!! LOL...what is a decent beginners plotter? I probably will EVENTURALLY branch out to the heat vinyl transfer(?) for shirts and other garments. Right now, it's mainly for my store signs and small decals for cars and stuff.

thank you for trying to help. I really appreciate your time

When I go to add a cutter it pulls the MH - 365, 721, 871, 1351 and then the SC2's, SC, and laserpoint 2 and 3 choices I have the MH-871 and everything else pulls up corresponding with that cutter.

Yes, I saw that too...but the baud rate will not allow me to choose anything under 9600. I actually sent a feedback to the website just now. the choices I have in the drop down box are: 9600, 19200, 38400, 57600, 115200 nothing under 9600

Oh yes, I have read everything I could pertaining to this problem...but I did not catch anything would help me. I even researched other forums. Yes, I did send a ticket. I hope they get back

i'm really sorry for the late reply...I am trying everything I can while I have someone here (forum --- you) with me. But when I restart the program it takes the spooler so long to close.

how do I find this out? I'm not 100% sure on that...I'm so sorry!! Also, the baud rate on the spooler is not letting me check anything under 9600. I can't change it to a 4800 because it doesn't give me that option. But I hit the "detect" button. the cutter instantaneously responds the first 2 tests, but there is about a 6 to 8 second pause...almost reaching that 10 seconds before the 3rd test responds.

Yes, I have already done so.

Yes I did. I would do that in the device manager menu, correct?

Hello all! I am having difficulty is sending jobs to be cut via VM spooler. So, I have downloaded the software and installed it on Win10. I am using COM3 (actually now COM4) with the serial cable connecting the cutter and PC. The PC can command the cutter to do an "area test" and it will go. The cutter will respond to the detection commands even. However, when I send a job through it will take FOREVER to even load halfway (and the cutter has not done anything yet). After 5 minutes I to cancel the job, the spooler will not respond and I have to abort the job. However, it is THEN the cutter will move and cut half of the job. So I did a "J" letter just to see what would happen...It took from hitting the "cut now" button to actually getting it cut....10 minutes. For 1 letter!!! That's not normal. I've had another plotter from this company but it didn't give me this hard of time. I checked device manager and the COM port it is using is active and recognizes the hardware. I have uninstalled and reinstalled the software...same thing. I have been working on this...seriously, for 2 days straight!!! Plllllllllleeeeeease someone help me :*( I just downloaded a trial of sure cuts a lot and it worked perfectly. What gives?? I really want to use vinylmaster since I have gotten used to it. Any suggestions anyone? Please? THanks, Jay