xiqshuner
Members-
Content Count
10 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout xiqshuner
-
Rank
Member
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
Ok ill try adjusting the blade again. Thanks again
-
I used a Peice of vinyl to check the blade. I also used a sticky pad and cut through one sheet.
-
When i got the machine it came with a 30 degree blade a 45 and a 60 but it said to use 30 degrees for heat transfers. I was making my kids shirts.
-
And when it goes to cut the blade is low enough to catch the vinyl not clearing over the top of it. Its like dragging on it
-
Ive ran the area test before with no issues.im sure what happen. I did just change the blade. It seems as if the blade is sitting too low its hard to slide the vinyl under it.
-
Im using a mh871 cutter vinyl master software that came with it. Im using a 30 degree blade about half the width of a credit card. My offset is .30 1 pass. HTV by siser. Pressure is 100 baug rate is 4800 up speed is 380. The cut speed is 300. Hp laptop windows 10
-
Im trying to run an area test to make sure the project will fit on the peice of vinyl I was using. And it cut down the vinyl. And then across. I just started cutting vinyl. So im not sure of many settings.
-
Not the test cut on the machine when im sending a project over and i run an area text to test the are its cutting the vinyl sry i did say area test cut but its just the area test
-
During the area test cut, the blade is cutting into my vinyl. How can I fix this. Thanks in advance.