HJL

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About HJL

  • Rank
    Newbie
  1. Hello everyone, I'm a new user of this CE6000 and so far.. I've only unboxed it, turned it on and performed test cuts. Blade length is correct and so is the force (12g), but my triangle has this strange line down the middle and overcut on the left triangle. Ths attached picture is cut at offset 30 and I've adjusted all down the spectrum and cannot seem to remedy this issue. Graphtec advised me to reset all factory settings and am still pending a response, as this did not solve the issue. Thanks in advance