NickP

Members
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About NickP

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. This has been very informative. Thanks. I cant really change the colors because its a face, so I think I'll just end up ordering bumper stickers. I'm going to take the gamble and hope they sell mainstream.
  2. The second option. I am looking to sell these. My design is in black vinyl and it does not look good in other colors. So for better visibility I wanted to make it a more traditional bumper sticker. I'm using the titan2 so it can contour cut and read registration marks but i have not used it to this point yet as i have just been cutting single layers of vinyl.
  3. Hello, I have used the boards for the last few months and it has really excelled my knowledge and ability, Thank You! So I have been looking to see if i can use black vinyl as the "printer" so i can contour cut a design. I am not looking to do anything complicated to start, but basically I have a few designs in black vinyl i want to cut and weed out with registration marks on my titan2, then overlay it on white vinyl to contour cut them into uniform 3x11 bumper stickers. I know that I can manually cut them but my ocd would not allow for it and I would throw it all away if they are not correctly centered. Has anyone successfully done this and bypasses the printer? Thanks!