Leaderboard


Popular Content

Showing content with the highest reputation on 10/09/2021 in all areas

  1. 2 points
    I know this is an old post and the original poster hasn't logged in since February 20th, but this may be helpful to future readers. Concerning the Prismcut not reading the registration marks and stopping short of the third registration mark, I believe it's a lighting issue since this cutter uses a camera to read the registration marks. Make sure the RGB lights are off and turn on the camera light and it should read the registration marks just fine. As for the second question, if I'm understanding the question, the OP wanted to contour cut in the landscape mode instead of the portrait mode. If this is correct, then all one needs to do is to click on the "properties" tab and go into "print setup" and just change to landscape mode. Once you click "OK", you will see the page has turned sideways and you're now in the "landscape" mode.
  2. 1 point
    The cutter will cut any vector line you have on your graphic, so if you want just the bottom to be a square cut out, the vector graphic you send to your cutter should only have a square. Meaning, if there's a design in the square, then make yourself a copy of your graphic (just in case), and then alter the copy by deleting any and all lines you do not want cut.
  3. 1 point
    If you have a Prismcut, use the "pause" button instead of the "stop" button.
  4. 1 point
    Hey, turtlemechanic, I have a really good suggestion for you ---- spend the fifty bucks and grab VinylMasterCUT. It's a very sophisticated program that you'll be happy with using for your work. Alternatively, give yourself a chance to see if you like SignBlazer, it'll run the SC just fine (use 'Liyu' for the model in setup). Not supported by anyone (except us, if you have specific questions, there are a few oldtimer users, including me, of that software).