Leaderboard

  1. MZ SKEETER

    MZ SKEETER

    Members

    • Points

      4

    • Content Count

      17,516

  2. haumana

    haumana

    Super Moderators

    • Points

      3

    • Content Count

      4,371

Popular Content

Showing content with the highest reputation on 09/05/2020 in all areas

  1. 2 points
    haumana
    you can check your offset and see if that will help.
  2. 2 points
    MZ SKEETER
    search for setting blade depth. It's been posted hundreds of times on here. When vinyl is lifting, you have too much blade exposed. Slow the cutter down.
  3. 1 point
    MZ SKEETER
    Roller marks don't hurt a thing, the marking is caused by the grit roller on the bottom of the wax paper backing.. They come out when you apply the vinyl in most cases. You start creating other problems when you go adjusting the pinch rollers.
  4. 1 point
    haumana
    make sure there is sufficient slack on the vinyl for the entire job to cut. slow the cut speed down.
  5. 1 point
    MZ SKEETER
    Correct blade depth is first to do, then your blade offset. Start at 0.25 mm then adjust 0.05 plus or minus Your welcome.