Leaderboard

  1. MZ SKEETER

    MZ SKEETER

    Members

    • Points

      2

    • Content Count

      17,516

  2. haumana

    haumana

    Super Moderators

    • Points

      1

    • Content Count

      4,371

  3. Dakotagrafx

    Dakotagrafx

    Super Moderators

    • Points

      1

    • Content Count

      21,363

  4. arty-rc

    arty-rc

    Members

    • Points

      1

    • Content Count

      1,366

Popular Content

Showing content with the highest reputation on 12/02/2019 in all areas

  1. 2 points
    MZ SKEETER
    On Graphtec site, it does not say that the FC5100 is compatible with the CM4. It says Compatible CuttingMaster 2 is. Your cutter is listed on FREE Signblazer. It is a design and cut program. That cutter is probably close to 13-15 years old. This is the software that you need with Cutting Master 2 WIN REQUIREMENTS ▼ Win 10/8.1/8/7, 32&64 Bits ADOBE LLUSTRATOR CS3 - CS6 CC CC2014 CORELDRAW X4 - X7
  2. 1 point
    arty-rc
    Thanks Skeeter, that was it. It had to be at least 7 years since I installed SBE in any computer. I guess the memory does get shorter the older we get.
  3. 1 point
    DecalGang
    I found the HP video after posting this. Also, found that Mimaki has a cross-cut cutter with a separate blade. Thanks a lot for your comments @Wildgoose and @haumana.