Call Support?
Now why would I want to do a thing like that? Nooooo! That's entirely too easy.
I would much rather crack a beer, have a seat, and bother the REAL people!
Just wanted to update anyone following.
I managed to get this rig running, finally. And I gotta tell ya...
It helps so much TO INSTALL THE CORRECT CUTTER! That entire time... I had SC2 selected, NOT the Titan 2.
After making the correct choice, the bells & whistles came alive. It was a Hallmark moment. No kidding. If any of you
could have seen my behavior, prior to choosing wisely, you'd have grabbed popcorn & a fountain drink. Yeah... it was sad.
Anyway... After a few test cuts, I noticed that the offset was too low (rounded, incomplete cuts). Of course, I headed
straight for the calibration thingy. That's where I'm stuck now. That's where you fine peoples come in. I got to the part
where the design shows up on the sign blank. Pretty sure it's a grid, with #'s & letters. Well, I hit CUT IT NOW. It starts cutting...
then stops... and just sits there. Your thoughts?