Leaderboard

I have the Summa D60 that I run with Flexisign. I have had the Summa for at least 10 years and have had only one problem. That was a power supply that went bad. it was probably my fault because I use to leave the power on for long periods of time. I did find a replacement power supply and it's been running great ever since. I have no experience with other programs but can imagine the cutter will run fine with something different and windows 10. That being said the Summa is a great vinyl cutter, they track very well and can cut very detailed designs. The title of this thread is D60 but in the original post you mention a T140. These are two different cutters. the t140 being tangential which is even better than the D60's drag knife design. Dakota gave you links to the Summa site for manuals and drivers. I hope this helps a little. you've got a great cutter.

Then crack a beer and go to the top of the layout screen where HELP is. Plenty of answers and tutorials for helping with your software. Most any software has HELP and the guides for using the software. There is even a keyword search. Sounds like your wanting to change the blade offset. Search blade offset. There is a tutorial that tells you how to do that. PS. I just might be older or close to you.

Call Support? Now why would I want to do a thing like that? Nooooo! That's entirely too easy. I would much rather crack a beer, have a seat, and bother the REAL people! Just wanted to update anyone following. I managed to get this rig running, finally. And I gotta tell ya... It helps so much TO INSTALL THE CORRECT CUTTER! That entire time... I had SC2 selected, NOT the Titan 2. After making the correct choice, the bells & whistles came alive. It was a Hallmark moment. No kidding. If any of you could have seen my behavior, prior to choosing wisely, you'd have grabbed popcorn & a fountain drink. Yeah... it was sad. Anyway... After a few test cuts, I noticed that the offset was too low (rounded, incomplete cuts). Of course, I headed straight for the calibration thingy. That's where I'm stuck now. That's where you fine peoples come in. I got to the part where the design shows up on the sign blank. Pretty sure it's a grid, with #'s & letters. Well, I hit CUT IT NOW. It starts cutting... then stops... and just sits there. Your thoughts?