Leaderboard


Popular Content

Showing content with the highest reputation on 04/27/2019 in all areas

  1. 2 points
    Looking at your first picture, I believe you are cutting too deep and cutting into the backing paper. Reset your blade length as per MZ SKEETER'S instructions and reduce your pressure settings. You should barely be making an indentation on the backing paper with your blade.
  2. 1 point
    Someone who uses SCALP will have to tell you how to set your design up to cut. I always used Flexi software with my Seiki. Never did like SCALP software. Just from looking at your design, you cut a square and triangle up in the right hand corner. That moves the word THE over to the left. Do some test cuts with the test feature on the vinyl cutter and get your blade depth correct.
  3. 1 point
    You should be peeling the wax paper backing off the decal. it makes a huge difference. Lay decal tape down, peel the backing off. No mention which vinyl or tape you are using,