Leaderboard


Popular Content

Showing content with the highest reputation on 04/25/2019 in all areas

  1. 2 points
    I refer you back to post 5 in this thread from sunday . . . .
  2. 2 points
    No problems with a desktop with 8 cores and 64gb ram either
  3. 1 point
    To add to this. When you click the Origin button, that is where your vinyl cutter starts to measure your design. When you click the ORIGIN button. Your cutter shows X 0 Y 0. That is the starting point. You should place your blade/ carriage head at the right lower corner of the vinyl. Click ORIGIN. That is when your cutter starts measuring the design that you send to to your vinyl cutter. ( The cutter may not start cutting there at that point. Most vinyl cutters start cutting at the point where the design was created. The cutter may advance on to the vinyl, but it will come back and finish the entire design. I make very large decals and my cutter may advance onto the vinyl 4 ft, before it starts cutting, but it will come back to the front of the vinyl and finish the whole design.) Make sure you have chosen the correct width and length orientation in your cutter software, so the vinyl cutter does not cut off of the vinyl or is too big for the vinyl. No reason to use WYSIWYG. You push the ORIGIN button before you send your design to the vinyl cutter.