Popular Content

Showing content with the highest reputation on 11/10/2018 in all areas

  1. 3 points
    Ms skeeter takes all the credit for this. This is the correct way to set your blade depth. To start with, you should set your blade depth correctly, by taking the blade holder out of the machine, and firmly cut across a piece of scrap vinyl, you will be cutting. You should only be cutting the vinyl and barely a mark on wax paper backing, Adjust blade to get there, Then put the blade holder back in machine, and use the force of the machine to get there, same results, only cutting the vinyl and barely a mark in wax paper backing. You should just barely see and feel the blade tip out of the blade holder.
  2. 1 point
    WAY to much blade from seeing that. Look for skeeters blade setting on here . It is everywhere.
  3. 1 point
    2 things I would check - I had a member on here say they couldn't use their latex for shirts - -- - I never looked into that part 2 plan on having an electrician run the new line for the HP latex - they don't just plug into the wall like the solvents do compare the 2 side by side at a show for how the colors pop. a friend that does installs for a living always said he loved installing the latex materials on walls etc but when he bought his own machine it was a roland eco solvent for what that is worth