I can do better than a screen shot; here are links to the actual USCutter pages (active 9/30/18) that say SC2 works with Macs:
From the "support" pages: https://support.uscutter.com/support/solutions/articles/14000030239-do-the-vinyl-cutters-work-with-macs-
Refurb'd SC cutter with SCALP3 included: https://www.uscutter.com/Refurbished-USCutter-SC-Series-Vinyl-Cutter-With-Sure-Cuts-A-Lot-Pro-Design-Cut-Software
The OLD USCutter SC2 page offered SC2 with a choice of VM or SCAL. In February or March, 2018, the option to include SCAL software with the cutter was dropped from the order page. On March 7 e-mailed support with this question (Ticket 79538):
"I'm about to buy a vinyl cutter, and I've settled on your SC2, but I can't get consistent information about whether it will work with my Mac (iMac/ OSX 10.11 / 4GB memory). Depending on where I look on your site, the SC2 either will or won't work with a Mac."
... and they replied,
"Sure cuts alot is the Mac option. I am working on getting this typo corrected thank you for bringing this to my attention."
The "will it or won't it work with a Mac" inconsistencies persist on their site, but I took the answer from support as true and bought the printer (it came with VM, which as far as I can tell, cannot use my system's fonts). I later upgraded to SCAL5 (not Pro) directly from Craft Edge (as suggested in USC's Aug 31 Webinar), which CAN use my system's fonts. Since my only use for this cutter is the creation of menu boards for carnival concession booths, the use of fonts is not just critical -- it's absolutely required.
Randy
The Zaar