Leaderboard


Popular Content

Showing content with the highest reputation on 05/14/2018 in Posts

  1. 2 points
    Essentially a 60 will work for everything, only "danger" is that the tip is smaller so it's easier to break it, but so long as you have the depth and pressure set correctly that shouldn't happen.
  2. 2 points
    Shameless plug but I finally set up a selling platform. I'm on etsy. I'm adding new listings everyday. Lets see where this goes. https://www.etsy.com/shop/GoCCreations
  3. 1 point
    Never a pain, and it's much better to have extra blades, than not enough. That being said, even though you might have stocked up on a bunch of blades - it is worth looking at Clean Cut blades if you did buy those. Not all blades are made equal.
  4. 1 point
    You've ruled out static as the problem with the pen test. Have you tried different software or cables? Are you using a USB cable or serial? Serial is a better option if you have one on your computer. If not, you can get a triplite keyspan usb-serial adapter.
  5. 1 point
    for years all I have used in all my cutters have only had 60 degree clean cut brand blades in them
  6. 1 point
    As for tracing, I'd find the state outline, they're pretty easy to find, and then manually trace the letters, they're all straight lines so it shouldn't be that hard.
  7. 1 point
    Good luck with it Jeff, those signs are amazing!
  8. 1 point
    Hey, a big congrats Go-C. He sure does look like a happy little critter there!
  9. 1 point
    He looks like a happy little guy. Congrats.
  10. 1 point
    first - your best work yet! did the first onsie say "just did 9 months on the inside?" or the one with the pacifier that read "say hello to my little friend?"
  11. 1 point
    Congrats and nice work