Leaderboard

I brought it into Flexisign and came up with this.

Weill if you are printing them as 8x10 that shouldn't be a problem then - I mentioned that because I get so many images from charities for coro signs that they send images pulled off their page that look bad at x3x3" much less 8x10. if you zoomed in on it on your screen and it is clear zoomed it , that and using the same media you have been using I am not sure what is going on - I use solvent and only problem I had was one time I got some latex only media in and that didn't go so well

Very little interior work on my end. Looks like they used root beer for app fluid.

Alex Brush Alfa Slab One

Try this one - I opened it in an older version of ai to get it to work on my flexi and added the contour from that program as I am more familiar with it. I tried it in my versaworks and it recognized my contour fine. I also deleted the blank white background so the background is transparent as you will be printing on a white substrate. sometimes the RIP will see slight areas in the white background and cause noise or a dirty background look ymla.eps