Leaderboard

I am not kysign, but start blade offset at 0.25MM. Then adjust at .05 + or minus until it looks good. Use the test feature on your vinyl cutter. Corners should be sharp. FIRST make sure your blade is set correctly, This is how. below. I know you said you did, but retry on the vinyl you are cutting at the time. Blade depth has to be set correctly first. To start with, you should set your blade depth correctly, by taking the blade holder out of the machine, and firmly cut across a piece of scrap vinyl, you will be cutting. You should only be cutting the vinyl and barely a mark on wax paper backing, Adjust blade to get there, Then put the blade holder back in machine, and use the force of the machine to get there, same results, only cutting the vinyl and barely a mark in wax paper backing. You should just barely see or feel the blade tip out of the blade holder....