GraphTec Cutting Plotter Discussion

General discussion pertaining to the GraphTec cutting plotters. (Please do not post support requests here)

484 topics in this forum

  1. Considering a GraphTec CE6000 Model. Question.

    By Kirk89,   
    • 26 replies
    • 3,158 views

  2. contour cut?

    By ACJ GRAPHICS,
    • 3 replies
    • 904 views

  3. Contour Cutting

    By markvvq,
    • 2 replies
    • 1,562 views

  4. contour cutting

    By wissam,
    • 0 replies
    • 752 views

  5. Contour cutting error

    By Robert2495,   
    • 2 replies
    • 1,211 views

  6. Contour cutting on a CE5000-40

    By edge,
    • 0 replies
    • 784 views

  7. Contour Cutting Question

    By Guest sciondrgn,
    • 21 replies
    • 4,322 views

  8. contour cutting question - i need hpgl code so i can compare what i have

    By tinaski,
    • 0 replies
    • 978 views

  9. Contour Cutting with Craft Robo Pro

    By tdp,
    • 1 reply
    • 1,604 views

  10. Contour Cutting with my Ce5000

    By gcextreme,
    • 14 replies
    • 1,831 views

  11. Contour Cutting...Yes, gonna be a silly question

    By lablover,
    • 26 replies
    • 6,995 views

  12. Corel 17 and Graphtec CE6000-60Plus

    By tstone5966,   
    • 2 replies
    • 881 views

  13. Craft Robo can't find registration marks, HELP!

    By Etreme Crash,
    • 7 replies
    • 4,746 views

  14. Craft Robo CC330L-20 cutting .13mm Velum

    By Spike,
    • 9 replies
    • 2,558 views

  15. Craft Robo Pro

    By pastortommy,
    • 1 reply
    • 1,143 views

  16. Craft Robo Pro losing its bearings and shooting off the end of A3

    By heleno,
    • 2 replies
    • 785 views

  17. Craft Robo Repeatability Tips

    By ugly,
    • 1 reply
    • 1,398 views

  18. CrossCut Not Cutting Entire Width

    By westman,   
    • 1 reply
    • 702 views

  19. Curves are Cutting Very Slowly

    By 13ruce,   
    • 3 replies
    • 2,046 views

  20. Cut Master 4 not centering on roll

    By KainX,
    • 0 replies
    • 620 views

  21. Cut10mil stencil with Graphtec CE-6000? Carrier for large designs?

    By mazi,   
    • 6 replies
    • 4,796 views

  22. Cutmaster 4 job setup question..

    By keith20mm,
    • 0 replies
    • 563 views

  23. cuts all over my "bar"

    By motoxchic,
    • 10 replies
    • 1,751 views

  24. cutter issues

    By Pineapple,
    • 22 replies
    • 1,434 views

  25. Cutter needs replacement

    By Cavitt complete window tin,   
    • 1 reply
    • 1,062 views