cutter

[DIRTRACER]

I have a p-cut, When I try to cut small letters like an a when I weed the center of the a pulls out. Am I doing something wrong? Thank you.

[mr300s]

do you have your offset set at .025 ? 

[Vette]

Check the depth of your blade.
Sometimes if it's too deep, it welds the vinyl to the backing.

[DIRTRACER]

Thank you,Offset at .025. Maby I should bring blade out more, this is happning when I am trying to do small leters for etching.

[mr300s]

Thank you,Offset at .025. Maby I should bring blade out more, this is happning when I am trying to do small leters for etching.

You could also try slowing the speed way down unless you have one of the pcuts that dont go below 50?

[DIRTRACER]

Thanks everyone,Yes I can slow way down.