Graphtec 5000-60 stops

[Renegade]

I've noticed that sometimes when a graphic is over 12" long (length of vinyl, not width) that my cutter just stops with no error.  Often I can take the same graphic and rotate it 90 degrees and then it will be less than 12" and it cuts just fine.  Is there a setting I'm missing or do I need more memory or what?

[FireMalt]

Ever find out what the issue was... luckily, I have not had the pleasure of experiencing this, nor to I hope to.

[Brandon_Davis]

I think I have read posts about this some where else... If this is really an ongoing issue I would love to help troubleshoot and eventually publish our findings...

[Renegade]

Yep, I figured it out eventually.  Its the page length setting that was defaulted to 11" on the cutter.  I can't remember what I set it too, but it was something like 1024.

[mr300s]

Yep, I figured it out eventually.  Its the page length setting that was defaulted to 11" on the cutter.  I can't remember what I set it too, but it was something like 1024.

Great info thanks for the update